Diamond core drill bits only last long if used for the correct application and maintained regularly. Unfortunately, some newbie contractors believe that diamond core drill bits can be mishandled and still perform optimally primarily because they are hardened. However, nothing could be further from the truth because even the most hardened construction tools need some tender loving care. Therefore, you must understand how to use core drill bits the right way to enhance their longevity. This article will highlight a few critical tips for using diamond core drill bits correctly.

Use the Recommended Drilling Speed

Diamond core drill bits operate through revolutions, and different materials require specific rates. There is often a misconception among newbie contractors that the faster a drill bit revolves, the better the results. However, it is not the case because different drilling conditions affect drill speeds. Factors that determine the optimal drilling speed include the diameter of the bit, the type of material, and the size of the particulate.

Avoid Reverse Drilling

Most drilling machines have reverse drilling capabilities. Not only are the drilling machines convenient, but they also tend to wear out slowly. However, it would help if you were careful when a using reverse drill because not all bits are designed to drill in reverse. The reason is that diamond core drill bits designed for standard drills have only one glazing end. Therefore, drilling in reverse leads to premature wear of the glazing end. You should only use the reverse spin of a drill if you have a reverse drill bit since it has two glazing ends that wear out evenly.

Do Not Cover the Drill Ventilation Holes

As mentioned earlier, diamond core drill bits are some of the most robust pieces of equipment. Therefore, they are the right drill bits for handling the hardest materials such as steel and reinforced concrete. However, drilling such materials puts a diamond core drill bit under intense pressure, which can easily generate a lot of heat. It is for this reason that drills are equipped with ventilation holes to prevent overheating. Unfortunately, some newbie contractors cover the ventilation holes when using diamond core drills, thereby increasing heat build-up. It is crucial to keep the ventilation holes open at all times since core drill bits wear fast when overheated.

For more information about diamond core drill bits, reach out to a diamond core drill supplier in your area today.